Please enter your email:
1.
1. (2) What safety equipment is provided on the Grader?
2.
2.(2) What should an operator look for during a visual inspection?
3.
3.(2) What should an operator do before operating the machine?
4.
4. What should an operator do if he / she finds a problem during an inspection or operational check?
5.
5. What steps do you take when stopping and parking the Grader?
6.
6. When checking for a hydraulic leak you can use
7.
7. The cooling system filler cap can be removed
8.
8. The hydraulic filler cap can be removed
9.
9. When starting the engine the maximum time the oil pressure should register is.
10.
10. If the transmission temperature is above normal or the high temperature alarm is on, you should.
11.
11. To prevent possible damage to the drive train, be sure the differential is unlocked before turning or maneuvering the machine on dry ground.
12.
12. Mount and dismount the machine only where hand holds and / or steps are provided.
13.
13. Never get off a moving machine.
14.
14. Graders do not need any warm up time.
15.
15. A good practice is to use the same gear range going down grade as you
would going up grade.
16.
16. Engine over speed going downhill is not a problem.
17.
17. Moisture from the air tank should be removed daily
18.
18 Point the end of the blade on the traffic side to the rear and away from the direction of travel when possible.
19.
19. You should decelerate before making directional changes.
20.
20. Excessive hydraulic down pressure on the blade increases traction.
21.
21. In normal leveling work, deliver the material between the wheels to ensure a
smooth surface for the rear wheels. (answer should be outside the rear
22.
smooth surface for the rear wheels.
23.
23. Hydraulic leaks don‘t have enough pressure to penetrate the skin.
24.
24. Batteries give off flammable fumes which can explode.
25.
25. A can of ether should be kept in the cab to assist starting if needed.
26.
26. Use 3 point contact, face the machine when mounting and dismounting.
27.
27. Operate the controls only when the machine is running.
28.
28. If there is enough room in the cab, a rider is permitted.
29.
29. The park brake is required whenever the machine is being left unattended.
30.
30. The seat belt is not necessary when working on a flat, level surface.
31.
31. When turning right lean the wheels to the right.
32.
32. If the motor is at low rpm, you can shift from forward to reverse without
using the brake.
33.
33. If the engine oil light comes on, you should drive the machine to the shop.
34.
34. Each time the Road Grader is used, the log book must be filled out.
35.
35. During grading operations the machine can be operated at speeds up to 24
Kilometers (15 miles) per hour. (Answer should be maximum 8-10
36.
36. Keep the front wheels on the shoulder to prevent wheel slippage when grading in a wet ditch.
37.
37. When checking oil level, equipment must be lowered, parking brake applied and engine stopped.
© JDL Underground Ltd. 2025
Type and press Enter to search
